网站转让 → 您的公司名称

刻线作为最简便提升机体细节信息量的方法，相对于切割胶板堆积零件，新人还是要必须掌握好这一基本功。
As the simplest way to improve the amount of details of the body's details, the newlyweds must master this basic work relative to the stacked parts of the cutting board.
刻线技巧延伸使用范例-LV2：来制作U型槽吧！
Line technique extends using example -LV2: to make U groove bar!
1.铅笔布线
1. pencil wiring
2.使用刻线胶带定位+刻线
2. using line tape positioning + engraved line
3.适当的使用不同宽度雕刻刀增加线条层次（0.125mm+0.3mm)
3. appropriate use of different width engraving knives to increase the line level (0.125mm+0.3mm)
4.使用2.0宽刀垂直定位长度
4. vertical positioning length using 2 wide knives
5.使用1.0-1.5mm钻头破孔
5. using 1.0-1.5mm bit breaking hole
6.使用宽刀压出U型槽边缘
6. use a wide knife to press out the edge of U groove
7.使用1.2宽刀清除内部残肉（愈轻愈好，一次清掉一些）
7. use a 1.2 wide knife to remove the internal residual meat (the lighter the better, the more it is cleared at a time).
8.在U型槽塞入市售改套件
8. in the U slot plug into the market
一样很简单，操作刀具小心，每一刀都是轻轻松松的完成！出力就不对了！
The same is very simple, operate the tool carefully, each knife is easy to complete! The force is wrong!