| 【技巧】U型槽，如何刻？ |
| 添加时间：2017/12/27 14:50:10 浏览次数： |
| 刻线作为最简便提升机体细节信息量的方法，相对于切割胶板堆积零件，新人还是要必须掌握好这一基本功。 As the simplest way to improve the amount of details of the body's details, the newlyweds must master this basic work relative to the stacked parts of the cutting board. 刻线技巧延伸使用范例-LV2：来制作U型槽吧！ Line technique extends using example -LV2: to make U groove bar! 1.铅笔布线 1. pencil wiring 2.使用刻线胶带定位+刻线 2. using line tape positioning + engraved line 3.适当的使用不同宽度雕刻刀增加线条层次（0.125mm+0.3mm) 3. appropriate use of different width engraving knives to increase the line level (0.125mm+0.3mm) 4.使用2.0宽刀垂直定位长度 4. vertical positioning length using 2 wide knives 5.使用1.0-1.5mm钻头破孔 5. using 1.0-1.5mm bit breaking hole 6.使用宽刀压出U型槽边缘 6. use a wide knife to press out the edge of U groove 7.使用1.2宽刀清除内部残肉（愈轻愈好，一次清掉一些） 7. use a 1.2 wide knife to remove the internal residual meat (the lighter the better, the more it is cleared at a time). 8.在U型槽塞入市售改套件 8. in the U slot plug into the market 一样很简单，操作刀具小心，每一刀都是轻轻松松的完成！出力就不对了！ The same is very simple, operate the tool carefully, each knife is easy to complete! The force is wrong! |
| 上一页 凹槽方通型材（U型方通、U型槽）运用及特点分析 |
| 下一页 u型槽模具 |
Copyright © 技术支持：遨游网络